Raspberry Pi Compute Module 5 Programming Jig

Beskrivelse

Programming time per board will vary with the size of the operating system image being loaded. It is expected that higher-volume customers will operate multiple units in parallel to achieve the desired throughput.

• Single-head design provisions one Compute Module 5 at a time.
• Mechanical clamping secures the Compute Module 5 in place during programming.
• Pogo pin interface connects directly to Compute Module 5 without a carrier board.
• LED status indicators communicate the current state of the jig and provisioning progress.
• Dual network connectivity connects the jig to the provisioning network by Ethernet (JIG ETH) or Wi-Fi, with a second Ethernet port (DUT ETH) for accelerated software transfer to the Compute Module 5 being programmed.
• Automated provisioning supports secure boot, full-disk encryption, and bare operating system installation.
• Compatible with Compute Module 5 (CM5) only