Home Assistant SkyConnect

249,00 kr. inkl. moms

Home Assistant SkyConnect er designet til at passe perfekt til Home Assistant-brugere. Enheden giver en nem forbindelse med Zigbee og vil understøtte Matter-specifikationer i fremtiden med en firmwareopdatering fra Home Assistant.

FORHÅNDSBESTILLING. Ordrer afsendes i december 2022.

Findes på restordre

Varenummer: 9858 Kategori:

Beskrivelse

FEATURES
● 2.4GHz Multi-Protocol USB Transceiver
● Zigbee/Thread/Matter
● USB v2.0 full-speed
● TX power up to +20dBm
● Silabs EFR32MG21 Wireless SoC
● Over-The-Wire (OTW) update support

Runs 2 Protocols Simultaneously

● Dual-Protocol operation (Zigbee, Matter)
● Made for Home Assistant, adaptable for any case
● Futureproof Wireless Transceiver
● Low-risk bundle device for Gateway

The product supports Over-The-Wire (OTW) Firmware Update via the USB interface, which allows easy and quick firmware updates for both protocols. The device is an EFR32 Series 2 (Silicon Labs EZSP v8) adapter that will transmit at a power of +20 dBm. The drive supports full-speed USB 2.0 when plugged into the included USB extender.

Home Assistant will provide an Addon that will contact the Ember Stacks for Zigbee and Matter. We will provide updates to the firmware on a consistent basis that will provide the best user experience from a Zigbee/Matter Adapter. The USB Stick will be Plug and Play, tightly integrated with the Zigbee Home Automation integration allowing for a beginner-friendly experience.

Specifications:

●  Support for Zigbee, Matter, and Thread
●  Over-the-wire (OTW) firmware updates
●  USB v2.0 full-speed

Technical Specifications:

●  Supply:5VDC/upto150mA
●  USB: v2.0 full speed (12Mbps)
●  Bridge: USB to UART, Silabs CP2102N

Mechanical Specifications:

●  Dimensions (LxWxH) : approx. 38.5 x 18 x 4,5mm
●  Weight: 4g

RF Specifications:

● Transceiver: Silabs EFR32MG21
● Frequency: 2.4GHz
● Antenna: PCB
● TX Power : up to +20dBm
● RX sensitivity : -104dBm (250kbps)
● Protocols: Zigbee, Matter, Thread
● Stack: EmberZNet Serial Protocol

The SkyConnect will not run Matter immediately on launch but using Home Assistant the firmware will be updated to enable Matter when the firmware is finished being developed. This is due to Matter not being release until November and not all of the information being available. Home Assistant is already working on their Matter implementation but more information will come after November.

Anmeldelser

Der er ikke nogle anmeldelser endnu.

Vær den første til at anmelde “Home Assistant SkyConnect”

Din e-mailadresse vil ikke blive publiceret.